News
Published by：
KEYOU PCB
October 14,2019
The PCB design seems to be complicated. It is necessary to consider the direction of various signals and the transmission of energy. The distress caused by interference and heat is also always present...
Published by：
KEYOU PCB
September 18,2019
First, the reason for the laminate process
Under normal circumstances, as long as the laminate is hot pressed for more than 30 minutes, the copper foil and the prepreg are basically completely comb...
Published by：
KEYOU PCB
September 06,2019
1. The outer frame (clamping edge) of the PCB panel should adopt a closed-loop design to ensure that the PCB panel will not be deformed after being fixed on the fixture;
2, PCB board width ≤ 260mm ...
Published by：
KEYOU PCB
September 02,2019
1.The bonding pad overlap:
The overlap of the pads (except for the surface mount pads) means the overlap of the holes. In the drilling process, the drill bit is broken due to multiple holes in one...
Published by：
KEYOU PCB
August 27,2019
To get the best performance from electronic circuits, electronic component boards are the support for circuit components and devices in electronics. Even if the schematic design of the circuit is corr...
Published by：
KEYOU PCB
August 21,2019
1. The PCB circuit board, the so-called printed circuit board (printed circuit board), usually called rigid board. It is a support in electronic components and is an important electronic componen...
Search
Hot Product
